meta data for this page
  •  

This is an old revision of the document!

ElektronIQ FPGA-Einmaleins

  • Altera Cyclone II FPGA Starter Board
  • Quartus II Web Edition
  • der FPGA heißt Cyclone II EP2C20F484C7

Quartus-Einstellungen

JTAG-Deamon unter Debian einrichten

Quartus uses a daemon, jtagd, as intermediate between the programming software and the device. This seems needlessly complicated, but does enable remote host programming apparently. The key points to configuring it correctly are: it must be able to access a list of FPGA descriptions, and run as root.

Copy the descriptions from your Quartus installation to the configuration directory of jtagd: 

mkdir /etc/jtagd
cp <Quartus install path>/linux64/pgm_parts.txt /etc/jtagd/jtagd.pgm_parts

(Note the change of name!)

Have jtagd start at boot by either placing it in the rc.d system, or simply place the following line in /etc/rc.local: 

<Quartus install path>/bin/jtagd

Quelle: Abschnitt “Configuring jtagd” http://www.eecg.toronto.edu/~laforest/USB-Blaster-Debian.html

den richtigen FPGA auswählen

…entweder beim Anlegen eines Projektes oder unter

Assignments --> Device --> Taget Device --> EP2C20F484C7

FPGA fest programmieren

…damit beim Einschalten gleich die eigene Konfiguration in den FPGA geladen wird.

Assignments --> Device --> Device and Pin Options --> Configuration --> Configuration Scheme --> Active Serial Assignments --> Device --> Device and Pin Options --> Configuration --> Use Configuration Device --> EPCS4

Programmer --> Mode --> Active Serial Programming --> Yes --> Add File --> *.pof auswählen

Auf dem Starter Board run/prog-Schalter auf --> PROG stellen.

--> Start

Pin assignts für Cyclone II FPGA Starter Board

FIXME