meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| eigenbau:regler:pidmareike:start [2022/01/07 17:37] – [Detailed Control Options] Specified default jumper positions and clarified purposes mgangnus | eigenbau:regler:pidmareike:start [2022/01/25 15:23] – [Test Protocol] default dispswitch positions mgangnus | ||
|---|---|---|---|
| Line 223: | Line 223: | ||
| * enable the P part by setting 2S5 to the up position. The I- and D-part remain disabled with 2S6 and 2S7 down. | * enable the P part by setting 2S5 to the up position. The I- and D-part remain disabled with 2S6 and 2S7 down. | ||
| * the internal control monitor signal at CONN8 should give the non-inverted signal with the same amplitude | * the internal control monitor signal at CONN8 should give the non-inverted signal with the same amplitude | ||
| - | * disable 2S5 and enable the I-part with switch 2S6. Signal either saturates or a sinusoidal signal is arising. Use dipswitch configuration | + | * disable 2S5 and enable the I-part with switch 2S6. Signal either saturates or a sinusoidal signal is arising. Use dipswitch configuration |
| * press 2S8 to check if the discharging of the integrator works. The signal should vanish for the time the button is pressed. | * press 2S8 to check if the discharging of the integrator works. The signal should vanish for the time the button is pressed. | ||
| - | * disable 2S6 and enable the D-part with switch 2S7. It should give a square-wave signal. Use dipswitch configuration 2S3 (0x00), 2S4 (0000) to get aan amplification of ca 1. | + | * disable 2S6 and enable the D-part with switch 2S7. It should give a square-wave signal. Use dipswitch configuration 2S3 (0x00), 2S4 (000x) to get an amplification of ca 1. |
| * Re-enable the P part fort the following tests | * Re-enable the P part fort the following tests | ||