meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
eigenbau:bipolar_current_driver:start [2021/10/29 16:07] mquensen [Schematic and layout] |
eigenbau:bipolar_current_driver:start [2021/10/29 16:09] (current) mquensen [Issue list] |
||
---|---|---|---|
Line 37: | Line 37: | ||
* There are too many pads for the output current. Not needed. | * There are too many pads for the output current. Not needed. | ||
* The PI-controller OPamp has a pin distribution that does not fit to its footprint, I think. | * The PI-controller OPamp has a pin distribution that does not fit to its footprint, I think. | ||
+ | * There is no option to discharge the Elko's in the OPA549 board. They remain charged for quite some time after turning off the power supply. | ||