meta data for this page
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
wiki:fpga [2012/09/19 12:24] – created jmatthias | wiki:fpga [2015/10/13 11:12] (current) – [Quartus-Einstellungen] kmk | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== ElektronIQ | + | ===== FPGA-Einmaleins ===== |
- | * Altera Cyclone II FPGA Starter Board | + | |
- | * Quartus II Web Edition | + | |
- | * der FPGA heißt Cyclone II EP2C20F484C7 | + | |
+ | * Quartus II Web Edition | ||
+ | * der FPGA heißt Cyclone II EP2C20F484C7 | ||
==== Quartus-Einstellungen ==== | ==== Quartus-Einstellungen ==== | ||
- | === FPGA Einstellen | + | === JTAG-Deamon unter Debian einrichten === |
+ | |||
+ | Quartus uses a daemon, jtagd, as intermediate between the programming software and the device. This seems needlessly complicated, | ||
+ | |||
+ | Copy the descriptions from your Quartus installation to the configuration directory of jtagd: | ||
+ | |||
+ | mkdir / | ||
+ | cp <Quartus install path>/ | ||
+ | |||
+ | (Note the change of name!) | ||
+ | |||
+ | Have jtagd start at boot by either placing it in the rc.d system, or simply place the following line in / | ||
+ | |||
+ | <Quartus install path>/ | ||
+ | |||
+ | |||
+ | Quelle: Abschnitt " | ||
+ | |||
+ | === den richtigen FPGA auswählen | ||
...entweder beim Anlegen eines Projektes oder unter | ...entweder beim Anlegen eines Projektes oder unter | ||
Line 26: | Line 46: | ||
--> Start | --> Start | ||
- | === Pin assignts | + | === Pin assignments |
FIXME | FIXME | ||
+ |