meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
eigenbau:regler:pidmareike:start [2022/08/04 08:42] – mquenseneigenbau:regler:pidmareike:start [2024/11/18 12:19] (current) – [Improvements] franzke
Line 68: Line 68:
  
 __**Dipswitches**__ __**Dipswitches**__
 +
 <wrap hi>New: Charts of all possible settings!</wrap> <wrap hi>New: Charts of all possible settings!</wrap>
 +
   * For all possible settings, see: {{ :eigenbau:regler:pidmareike:first_amp_settings.pdf |1st amp}}, {{ :eigenbau:regler:pidmareike:i-part_settings.pdf |I-part}}, {{ :eigenbau:regler:pidmareike:d-part_settings.pdf |D-part}}, {{ :eigenbau:regler:pidmareike:final_amp_settings.pdf |final amp}}.   * For all possible settings, see: {{ :eigenbau:regler:pidmareike:first_amp_settings.pdf |1st amp}}, {{ :eigenbau:regler:pidmareike:i-part_settings.pdf |I-part}}, {{ :eigenbau:regler:pidmareike:d-part_settings.pdf |D-part}}, {{ :eigenbau:regler:pidmareike:final_amp_settings.pdf |final amp}}.
  
Line 304: Line 306:
   * The SMA connectors (CONN1, CONN3, CONN4, CONN6, CONN8,CONN9, CONN10, CONN11, CONN12, CONN13) should be positioned further back in order to leave enough space to prevent unwanted connections between ground and the front plate.   * The SMA connectors (CONN1, CONN3, CONN4, CONN6, CONN8,CONN9, CONN10, CONN11, CONN12, CONN13) should be positioned further back in order to leave enough space to prevent unwanted connections between ground and the front plate.
   * The hole for 2S8 is located slightly too low in the front plate   * The hole for 2S8 is located slightly too low in the front plate
 +  * In general the position of most of the holes in the front plate fits not too well