meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
wiki:fpga [2012/09/19 12:32] – [Quartus-Einstellungen] jmatthiaswiki:fpga [2015/10/13 11:10] – [Quartus-Einstellungen] kmk
Line 1: Line 1:
-===== ElektronIQ FPGA-Einmaleins ===== +===== FPGA-Einmaleins ===== 
-  * Altera Cyclone II FPGA Starter Board + 
-  * Quartus II Web Edition + 
-  * der FPGA heißt Cyclone II EP2C20F484C7+    * Altera Cyclone II FPGA Starter Board 
 +    * Quartus II Web Edition 
 +    * der FPGA heißt Cyclone II EP2C20F484C7
  
 ==== Quartus-Einstellungen ==== ==== Quartus-Einstellungen ====
 +
 +=== JTAG-Deamon unter Debian einrichten ===
 +
 +Quartus uses a daemon, jtagd, as intermediate between the programming software and the device. This seems needlessly complicated, but does enable remote host programming apparently. The key points to configuring it correctly are: it must be able to access a list of FPGA descriptions, and run as root.
 +
 +Copy the descriptions from your Quartus installation to the configuration directory of jtagd:
 +
 +  mkdir /etc/jtagd
 +  cp <Quartus install path>/linux64/pgm_parts.txt /etc/jtagd/jtagd.pgm_parts 
 +
 +(Note the change of name!)
 +
 +Have jtagd start at boot by either placing it in the rc.d system, or simply place the following line in /etc/rc.local:
 +
 +  <Quartus install path>/bin/jtagd
 +
 +
 +Quelle: Abschnitt "Configuring jtagd" http://www.eecg.toronto.edu/~laforest/USB-Blaster-Debian.html
  
 === den richtigen FPGA auswählen === === den richtigen FPGA auswählen ===
Line 26: Line 46:
 --> Start --> Start
  
-=== Pin assignts für Cyclone II FPGA Starter Board ===+=== Pin assignments für Cyclone II FPGA Starter Board ===
 FIXME FIXME
 +
 +
 +
 +{{upload>@page@|OVERWRITE}}