meta data for this page
  •  

This is an old revision of the document!


OpAmpSixPlusAdder

A PCB for six freely choosable OP amp circuits.

Funktion

  • On this board six OPamp circuits can be set up
    • I did my best to include many possibilities for filters and the usual OPamp circuits
  • It also includes:
    • An adder for the six potential output signals
    • A potential supply
    • A adjustable voltage “reference”, i.e. a voltage divider with trimmer that uses the positive or negative supply
  • as input and output ports SMA or two smoldered wires can be used
  • SMD “jumpers” can be used to choose between the different options
  • The outputs all share their GND
  • The output of OPamp n can be used as input for Opamp n+1 with an SMD jumper

Entwickler

Martin Quensen, quensen@iqo.uni-hannover.de

Schaltplan

Layout

  • Abmessungen der Leiterplatte: 50 mm x 166.5 mm
  • Versorgung: extern or intern, symmetric, PSK 3 pin or JAE 3 pin
  • Eingang: SMA or two wires (smoldered to pads)
  • Ausgang: SMA or two wires (smoldered to pads)
  • Anzeigen: LED for supply :)
  • Der Bestückungsdruck:
  • Die gezippten Gerberdaten für die Bestellung der Platine
  • Die : PCB Datei
  • Ein PNG vom Layout ist hier

Meckerliste

Was für die nächste Version zu tun ist: (:no:: verworfen, :Ok:: in Arbeit, :ok:: im Schaltplan, aber noch nicht im Layout, :OK:: erledigt)

  • Footsprints für die Dioden sind zu klein für die minimelf Teile.
  • Bei den (optionalen) Spannungsreglern fehler Rücklauf-Dioden.